Here's the description and part numbers for both sides:
72410-SZT-003 -- Molding Assy., R. FR. Door
72450-SZT-003 -- Molding Assy., L. FR. Door

 

Thank you tons why why why would they put it with the underbody and not the door assembly.

 

You can try hondapartsnow. I usually buy OEM parts from them.

 

Thought I’d add to this thread rather than create a new one. When I put my windows down any ‘misting’ or rain etc doesn’t clear at all. Is it time to replace the weatherstrip with the parts mentioned above or are the seals not supposed to clear the windows? The ‘felt’ has dried out on them quite a bit.

 

If I understand you correctly they are not supposed to clear the windows. Consider Rain X for the outside and cleaning the inside and outside very well with a non ammonia glass cleaner like Stoners Invisible glass and then for the misting/fogging on the inside you can also consider Rain X anti fog if issue still occurs after the good glass clean. You will not believe how much grey comes off the glass when cleaned properly. Clean glass first prior to applying Rain X.

When cleaning glass go vertical on one side and horizontal on the other so you can see which side the streaks are on.

 

In my case is that same story like yours. It will be interesting to hear what other users say...

 

I always use an old wiper blade to remove condensation from side and back windows (lack of rear wiper)

 

I keep a folding extendable rubber edged squeegee in my back of seat pocket on the passenger side and use it whenever I come out to the car and it is raining or wet. it has a rubber edge and a foam scrubber edge. I need to redo my Rain X once that is done there will be no water on the glass or at least no water spots .

 

I replaced my window seals because they were shot, but they still don't clear water from the glass- they just provide a seal when the window is fully closed.
If you watch the door as the window moves you'll see that the seal is not in contact with the glass until it hits the top, at that point the door skin actually deflects slightly moving the seal against the window.

 

Thanks all. No need to replace mine yet it seems. Some good tips/advice also! Love this forum!

 

Hi guys,

I am aware that this post is quite old, however I was hoping to get some advice. I have recently realised that the outside seal on my crz has started perishing (I have attached photos explaining what I mean). I have a 2010 model and right side steering as I am in the UK but I was hoping to get some advice on getting a replaced part, I am aware that the part number is provided in an earlier post, however I am unsure if that will fit my car as the description on website says models 2011 and upwards.

Any help would be greatly appreciated !

Thanks,

 

Late reply - but Honda started production of the CR-Z in 2010, so I believe the 2010 and 2011 are the same car (From the same production run)

The parts should be the same.