[KennyX]

I think that's a cut & welding thing, can't ses other methods

 

[KennyX]

Is there a sound clip anywhere? This has got to be my next mod once I start my new job on Monday.

Here it is

http://youtu.be/vRwBmKai-4M

 

[KennyX]

Kenny, I did my Noblesse install by just driving the rear wheels up onto some $30 plastic ramps and using a garage creeper (also $30) and hand tools. No problems. The screwdriver and lubrication are good tips for sliding the holders out of the rubbers. You can use an air or electric impact wrench to loosen the bolts, if need be, but I didn't have to. Note that the bolts ahead of the muffler are incredibly long (and tie into spring loaded nuts to seal the joint). You have to be prepared to back these off FOREVER!

Te Remus DOES look great, on the blue and the red.

Thanks for the tips. Bought yesterday a 20$ chain pipe wrench set; it broke almost immediatly guess I'll have to spend a little bit more.

 

[KennyX]

I went to a DIY garage and rented a lift.

There's no "DIY garage" here in Italy, and sadly I don't have a mechanic as friend, I'll have to work without a lift

 

[KennyX]

Having air-tools and a lift available reduces the risk of serious injury, death or worse

I already have 4 of these; what type of air tools are you suggesting? Btw, I'll have to figure how to remove the rubber mounts.

 

[KennyX]

Considering the side exit one. If you don't mind, I'd like a DIY for removing the stock one!