[JohnnyXmas]

What wires do you need info on? The CR-Z radio harness conforms to the standard color code that nearly call cars do, found here:

Wiring Harness Color Standards - Knowledge Base

Additionally, pin 16 (4th from the bottom-right, while looking at the pin side of the car harness) is for the steering wheel control signals, and pin 5 (5th form the top-right) is the ground pin for said control signals.

What are you looking for that isn't answered here?

 

[JohnnyXmas]

does anyone know where to run the power cable in a manual car since the clutch plate is not an option? and does anyone have a wire diagram for the radio because there is no factory sub cable like redefinedcrz stated there was, this is a base model and i could not find that cable anywhere behind that panel.

Just run it through whatever hole exists in the firewall already, or (and this is WAY easier) just drill a new one. It's not a big deal. You can peel the soundproofing back and it will cover up the hole if you ever remove the wire.

As for the sub wire, you are correct, it's not back there on the base model. You're going to want to patch into one of the rear speaker wires, and run the wire to the HI LEVEL input on your amp. DO NOT RUN TO THE LOW LEVELS. If you don't have hi level inputs, then you will need a line converter.