Joined
·
1,371 Posts
The cast section looks great. No joke about the other end, what a disaster that is.
Posts by ryanthegreat1
1 - 4 of 11 Posts
Joined
·
1,371 Posts
Keep us updated. I have a vband turbo manifold for a K series I want to print.
Joined
·
1,371 Posts
You don't think an as printed vband would seal? Or maybe leave a little stock to smooth just the sealing face?
Joined
·
1,371 Posts
Use a printing technology that doesn't use sintering at the final stage to avoid the shrinkage?
I wasn't too worried about the V side of the flange. The clamps have no issues working with rough cast turbine housing most OEMs are using. Just the flat mating surface I would think needs to be flat and smooth. I was going really simple and knocking off the high spots on the mating face with a belt grinder.
I wasn't too worried about the V side of the flange. The clamps have no issues working with rough cast turbine housing most OEMs are using. Just the flat mating surface I would think needs to be flat and smooth. I was going really simple and knocking off the high spots on the mating face with a belt grinder.
1 - 4 of 11 Posts
