![]() |
|
|||||||
| Register | Home | Forum | Garage | Gallery | Members List | Search | Today's Posts | Mark Forums ReadAuto Escrow | Insurance | Auto Loans |
![]() |
|
|
Share | LinkBack | Thread Tools | Display Modes |
|
|
#1 (permalink) |
|
Supporting Vendor
|
I just got these JDM Bumper reflectors installed to our CRZ These reflectors comes in a set of 2 and they are very easy to install.You can see the picture of the product here : JDM Rear Bumper reflectors Here's my D.I.Y. instructions and I hope this is not too confusing ![]() Step 1: You may need to jack up the car a little bit when you do it. Remove the diffuser off the bumper. The diffuser is held by 3 clips on each side so once you remove the clip, pull it gently and it will come out smoothly. Look behind the diffuser and there's a tab where you can push **shown in the pic** After you push the dummy cap will come right off ! ![]() Step 2: Install the reflector onto that slot and then bolt it down with the philips screw which comes with the reflectors. ![]() Step 3: Re-install the diffuser and double check everything to make sure everything is secured. Step 4: YOU are DONE ! ![]() The entire installation took me about 15 mins. If you have any questions, please POST ![]() Thanks Ben
__________________
--------------------------------------------- A&J Racing International #155 - 1991 Savage Rd. Richmond B.C. V6V 0A4 TEL: (604)279-0329 Email: info@aj-racing.com URL: www.aj-racing.com Your JDM parts and Honda Tuning Specialist AJR Facebook GROUP http://www.facebook.com/profile.php?...0232140&ref=ts ---------------------------------------------- |
|
|
|
|
|
#3 (permalink) |
|
Senior Member
Join Date: Sep 2010
Location: Orlando, FL
Posts: 422
|
has anyone checked to see if the rear reflectors from the Insight will fit the CRZ? they appear to be a similar shape.
__________________
'11 PWP, 6 spd, EX-Navi Heavily braced but slightly under powered. |
|
|
|
![]() |
| Thread Tools | |
| Display Modes | |
|
|